Mighty Skins Drone: How to Apply and Remove the Skins

Mighty Skins Drone: How to Apply and Remove the Skins

Mighty Skins are vinyl decals that offer protection and customization for your drones. Here's a breakdown of how to apply and remove them:

Applying a Mighty Skin:

1. Prepare Your Drone:

* Clean your drone thoroughly with rubbing alcohol and a microfiber cloth. This removes dirt, grease, and fingerprints that can hinder adhesion.

* Allow the drone to dry completely before applying the skin.

2. Unpack the Skin:

* Remove the Mighty Skin from its packaging.

* Make sure the skin is free of creases and wrinkles.

* If you're applying a multi-piece skin, lay out the pieces in the correct order and identify the "front" of each piece.

3. Start with the Largest Piece:

* If applicable, start with the largest piece of the skin (e.g., the main body panel).

* Align the skin with the drone's surface and apply it slowly, starting from one corner.

4. Smooth Out the Skin:

* Use a squeegee or a credit card to smooth out the skin from the center outwards, removing any air bubbles.

* Work carefully to avoid scratching the drone's surface.

5. Repeat for Other Pieces:

* Apply the remaining skin pieces, aligning them carefully with the previous pieces.

* Use a hair dryer on low heat to help soften the skin and remove wrinkles.

6. Trim Excess Skin:

* Once the skin is completely applied, use a sharp blade or scissors to trim away any excess around the edges.

7. Let it Set:

* Allow the Mighty Skin to set for at least 24 hours before using your drone. This allows the adhesive to fully bond.

Removing a Mighty Skin:

1. Warm Up the Skin:

* Use a hairdryer on a low heat setting to warm the skin, making it easier to remove.

2. Start from a Corner:

* Gently peel a corner of the skin away from the drone.

3. Pull Slowly and Carefully:

* Slowly peel the skin back, working your way along the drone.

* Avoid pulling too forcefully to prevent damaging the skin or the drone.

4. Remove Residue:

* If any adhesive residue remains, use rubbing alcohol and a microfiber cloth to clean it off.

Tips for Applying and Removing Mighty Skins:

* Work in a clean, dust-free environment.

* Avoid applying the skin in direct sunlight or high humidity.

* If you make a mistake, you can peel the skin back and reapply it.

* Apply the skin to a flat surface first to practice before applying it to your drone.

* Always use gentle pressure when applying and removing the skin.

By following these steps and taking your time, you can easily apply and remove Mighty Skins on your drone, giving it a fresh look and additional protection.